6-pin Heavy Duty Straight Harness – HRN-DS06S4


SKU: HRN-DS06S4 Category:


This 6-pin straight harness model HRN-DS06S4 is required to connect the Geotab GO tracking device to a North American heavy duty engine diagnostics (Deutsch connector) port.

The 6-pin connector is found mostly in older trucks.


  • Used to extend the placement of the Geotab GO tracking device.
  • This harness moves the GO device out of the way of the driver. 
  • Allows for convert installation.
    Once installed, the Geotab GO tracking device is not visible, out of sight and inaccessible to drivers and thieves.

Length: 39 inches (100 cm). 


How to Install Geotab’s 6-Pin Heavy Duty Extension Harness for Geotab GO tracking device

Learn how to install your Geotab Vehicle Tracking Device safely and securely with Geotab’s 6-Pin Extension Harness. The specific harness required for your vehicle depends on which port connection your vehicle has. Follow the instructions in this video to ensure your fleet management device has been properly installed.

To check the status of your installed Geotab GO Plug-&-Play Vehicle Tracking Device, visit: https://myadmin.geotab.com/install.htm

If you are unsure about the connector your vehicle has or what harness you need, please contact GPS Tracking America for further assistance.

NOTE: This video refers to a 9-pin connector.  The installation method is exactly the same for a 6-pin connector.

Additional information

Weight .3 lbs
Dimensions 6 × 5 × 2 in